Device Simulation Suite for Memory-mapped Devices

Do you need to get started developing driver and application software for your new hardware months before it arrives?

Might the FPGA or ASIC definition of your device be under revision for a while?
Might your first shipment of new hardware units be fewer than your development staff?
If so – HTF Consulting is proud to offer a suite of Windows software serving as a device simulation framework for memory-mapped devices (PCI, etc).

The simulation implements the memory-mapping bus as an abstraction, but it is just like PCI under the hood.

View this article on PCI Device Simulation for Device Driver Development .

A picture is worth a 1000 words…

MadSimDFDiagram_thumb

A video demonstration is worth 10,000 words. Please view the video for a 90 second demonstration of the device simulation suite in operation…

MadSimDemo2

The simulated device may be a storage device or anything connected to a host/controller over a wire.
The device may be sequential and/or random access. It may be buffered and/or direct i-o (DMA).

The device management functions in the driver may be implemented as common code in various environments; Windows, Linux, etc.

The simulation can inject many hard to reproduce problem states; recoverable and non-recoverable errors.  The simulation allows rapid plugins, unplugs and changes in power state for the active device(s).  Many devices can be active at once. All of this helps to fully exercise the device driver in development.

The two drivers in the simulation suite – the target device and the bus & device simulation – are both written in Kernel-Mode Driver Framework.  They are capable of WPP Tracing and/or KdPrint direct to a kernel debugger.

All components of the software suite are thoroughly documented in the source code. All are built as projects in one common VS-2013 solution.

The model device simulation suite is available as a zip file here: (32bit)…
The model device simulation suite is available as a zip file here: (64bit)…

Unzip the file to its own directory and then follow the instructions in Readme.Mad.txt.

Working through the tutorial completely will probably require an hour. A brief overview should only take 20 to 30 minutes. Remember to refer back to the online demo for help when necessary.

HTF Consulting is happy to provide more information and/or consulting about device simulation. Please drop us E-mail at: mailto:inquiry@htfconsulting.com

To display the resume of Tom Fones, click here. Resume2016.pdf